LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Transfer Case - Mp 3010 (NP0)) >> Repair Instructions - On Vehicle >> Transfer Case Fluid Replacement

Transfer Case Fluid Replacement

WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transfer Case Drain Plug & Fill Plug
GM1836287Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
1 Transfer Case Drain Plug
CAUTION:

Refer to Component Fastener Tightening Caution .

Procedure

  1. Allow the transfer case to drain completely.
  2. Apply sealant to the plug threads. Refer to Adhesives, Fluids, Lubricants, and Sealers .
NOTE:

Use only hand tools to remove and install the drain plug.


Tighten 
18 N.m (13 lb ft)
2 Transfer Case Fill Plug

Procedure

  1. Fill the transfer case to the bottom of the fill plug hole with transfer case fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Apply sealant to the plug threads. Refer to Adhesives, Fluids, Lubricants, and Sealers .
NOTE:

Use only hand tools to remove and install the fill plug.


Tighten 
18 N.m (13 lb ft)
scientia non olet · About LEMON Manuals