Input Shaft Seal and Front Output Shaft Seal Installation
WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Input Shaft Seal and Front Output Shaft Seal Installation
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Input Shaft Seal Procedure Use the DT-50648 - A or J-42738 . Refer to Input Shaft Seal Installer Revisions in New Product Information .
NOTE:
Special Tools
For equivalent regional tools, refer to Special Tools . |
| 2 | Transfer Case Front Output Shaft Seal Special Tools
For equivalent regional tools, refer to Special Tools . |
| 3 | Transfer Case Front Output Shaft Oil Slinger - Model Dependent Procedure The new design front output shaft oil slinger can be installed onto all current and prior model year Magna NQF, NQG, NQH, and NP0 applications providing the new design front output shaft is also installed. Refer to New Product Information . Special Tools
For equivalent regional tools, refer to Special Tools . |
| 4 | Transfer Case Assembly Procedure Remove from J-3289-20 Holding Fixture and remove the J-45759 Assembly Fixture from the transfer case. Special Tools
For equivalent regional tools, refer to Special Tools . |