Circuit/System Verification
WARNING: This page is about a different car, the 2017 GMC Yukon XL, 2017 GMC Yukon, 2017 Chevrolet Tahoe, and 2017 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode & Engine - Off
- Verify DTC P0502, P0503, P0721, P0722, P0723, P077C, P077D, P2160, P2161 is not set.
- If any of the DTCs are set Refer to:Diagnostic Trouble Code (DTC) List - Vehicle
- If none of the DTCs are set
- Ignition On - Engine Running - Greater than 1 min
- Ignition/Vehicle Off, key out of the ignition/keyless start transmitter 1 m (3 ft) from the vehicle, and all vehicle systems Off.
- Greater than 2 min
- Ignition - On / Vehicle - In Service Mode & Engine - Off
- Verify DTC P17D4, P185F, P279A, P279B, P279C is only set as a history DTC.
- If any of the DTCs are set Refer to: Circuit/System Testing
- If any of the DTCs are set as history Refer to Diagnostic Aids before proceeding with Circuit/System Testing.
- If none of the DTCs are set
- Clear All Vehicle DTCs
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify DTC P17D4, P185F, P279A, P279B, P279C is not set.
- If the DTC is set
Refer to: Circuit/System Testing
- If the DTC is not set
- If the DTC is set
- All OK.
NOTE:
It may take up to 2 min for all vehicle systems to power down.