LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls And Fuel - 6.0L (L96) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0315: Crankshaft Position System Variation Not Learned >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The Crankshaft Position Variation Learn procedure may have to be repeated up to 5 times before the procedure is successful.

  1. Perform the scan tool Crankshaft Position Variation Learn procedure.
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
  3. Verify the DTC is not set.
    • If the DTC sets 

      Replace the K20 Engine Control Module.

    • If the DTC does not set 
  4. All OK
scientia non olet · About LEMON Manuals