LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> Escalade ESV Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls And Fuel - 6.0L (L96) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0128: Engine Coolant Temperature (ECT) Below Thermostat Regulating Temperature >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2017 Chevrolet Suburban 3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0116, P0117, P0118, or P0119 is not set.
    • If a DTC is not set 
  2. Verify the cooling system is filled to the correct coolant level. Refer to Cooling System Draining and Filling (Static Fill L96)Cooling System Draining and Filling (Vac N Fill L96) , and Loss of Coolant (L96) .
    • If the coolant level is not correct 

      Repair as necessary

    • If the coolant level is correct 
  3. Engine running for 15 min with the A/C OFF, increase the engine speed to 3, 000 RPM.
  4. Verify the scan tool ECT Sensor parameter is greater than 80°C (176°F).
    • If less than 80°C (176°F) 

      Replace the Engine Coolant Thermostat.

    • If greater than 80°C (176°F) 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals