Conditions for Running the DTC

P0030-P0032, P0036-P0038, P0050-P0052, or P0056-P0058

• The ignition voltage is greater than 11 volts.
• The engine speed is greater than 400 RPM.
• The DTCs run continuously when the above conditions are met for greater than 6 s.

P0053, P0054, P0059, or P0060

• DTCs P0111, P0112, P0113, P0114, P0116, P0117, P0118, P0119, P0128, or P262B are not set.
• The ignition voltage is less than 32 volts.
• The engine run time is less than 1 second.
• The ignition is OFF for greater than 8 hours.
• The engine coolant temperature (ECT) is greater than -30°C (-22°F) at engine start-up.
• The ECT and the intake air temperature (IAT) are within 8°C (14°F) at engine start-up.
• The DTCs run once per drive cycle when the above conditions are met.

P0135, P0141, P0155, or P0161

• DTCs P0116, P0117, P0118, P0119, or P0128 are not set.
• The ignition voltage is greater than 10 volts.
• The heated oxygen sensor is at operating temperature.
• The heated oxygen sensor is commanded ON.
• Heated oxygen sensor device control is not active.
• The DTCs run twice per drive cycle when the above conditions are met for greater than 120 seconds.