Transmission End Play Measurement

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission End Play Measurement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Turbine Shaft Procedure Ensure the foot of the dial indicator is flat with the load gauge face. Apply 50 psi of pressure to DT-50903 load gauge and zero out the dial indicator. Using a torque wrench, tighten the forcing screw on GE-8433-1 puller bar to 10 N.m (90 lb in). Observe the dial indicator measurement. Refer to 1-3-5-6-7 Clutch Thrust Bearing Washer Specifications to determine the correct 1-3-5-6-7 clutch thrust bearing washer. Special Tools DT-45124 Removal Bridge DT-48056 Spring Compressor Bridge DT-50903 Clutch Travel Load Gauge GE-8001 Dial Indicator Set GE-8433-1 Puller Bar For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Turbine Shaft

Procedure

Ensure the foot of the dial indicator is flat with the load gauge face.
Apply 50 psi of pressure to DT-50903 load gauge and zero out the dial indicator.
Using a torque wrench, tighten the forcing screw on GE-8433-1 puller bar to 10 N.m (90 lb in).
Observe the dial indicator measurement. Refer to 1-3-5-6-7 Clutch Thrust Bearing Washer Specifications to determine the correct 1-3-5-6-7 clutch thrust bearing washer.

Special Tools

DT-45124 Removal Bridge
DT-48056 Spring Compressor Bridge
DT-50903 Clutch Travel Load Gauge
GE-8001 Dial Indicator Set
GE-8433-1 Puller Bar

For equivalent regional tools, refer to Special Tools .