Transmission End Play Measurement Set Up (Step 1)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission End Play Measurement Set Up (Step 1)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Output Shaft Procedure Install the GE-8433-1 puller bar and thrust bearing from DT-45124 removal bridge with two 16 in M10x1.5 threaded rods, nuts and washers, as shown. Loosely tighten the forcing screw on GE-8433-1 puller bar. Special Tools DT-45124 Removal Bridge GE-8433-1 Puller Bar For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Output Shaft

Procedure

Install the GE-8433-1 puller bar and thrust bearing from DT-45124 removal bridge with two 16 in M10x1.5 threaded rods, nuts and washers, as shown.
Loosely tighten the forcing screw on GE-8433-1 puller bar.

Special Tools

DT-45124 Removal Bridge
GE-8433-1 Puller Bar

For equivalent regional tools, refer to Special Tools .