Stator Shaft Support Assemble (8L45)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Stator Shaft Support

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Torque Converter Fluid Seal CAUTION: Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage. CAUTION: Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage. Procedure Use DT-51196-1 seal protector and DT-51196-2 seal pusher to install the seal. Use the large taper side of DT-50912-1 seal sizer for initial seal sizing, then flip the tool over for final sizing. Special Tools DT-50912 Seal Installer DT-51196 Seal Installer For equivalent regional tools, refer to Special Tools .
2	1-3-5-6-7 Clutch Fluid Seal Ring (Qty: 2)

Callout

Component Name

Torque Converter Fluid Seal

CAUTION: Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.

CAUTION: Size the fluid seal rings for at least 5 minutes after installation to obtain proper seal ring size. Failure to do so may cause internal transmission leaks and transmission damage.

Procedure

Use DT-51196-1 seal protector and DT-51196-2 seal pusher to install the seal.
Use the large taper side of DT-50912-1 seal sizer for initial seal sizing, then flip the tool over for final sizing.

Special Tools

DT-50912 Seal Installer
DT-51196 Seal Installer

For equivalent regional tools, refer to Special Tools .

1-3-5-6-7 Clutch Fluid Seal Ring (Qty: 2)