Automatic Transmission Fluid Pump Assembly Installation
WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Automatic Transmission Fluid Pump Assembly Installation
| Callout | Component Name |
|---|---|
| 1 | Automatic Transmission Fluid Pump Locator Pin (Qty: 2) |
| 2 | Automatic Transmission Fluid Passage Sleeve |
| 3 | Automatic Transmission Fluid Pump Drive Shaft Bushing |
| 4 | Automatic Transmission Fluid Pump Gasket
NOTE:
Install a NEW gasket, it is not reusable.
|
| 5 | Automatic Transmission Fluid Pump Seal Procedure Install the seal onto the pump as shown. "Side Up", indicated by the arrow, should face away from the pump assembly.
NOTE:
Install a NEW seal, it is not reusable.
|
| 6 | Automatic Transmission Fluid Pump Assembly |
| 7 | Automatic Transmission Fluid Pump Bolt M6 x 28 (Qty: 5)
CAUTION:
Refer to Fastener Caution
. Procedure Tighten the bolts in the sequence shown. Tighten 9 N.m (80 lb in) |