Control Valve Body Assembly Removal
WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Control Valve Body Assembly Removal
| Callout | Component Name |
|---|---|
| 1 | Manual Shaft Detent Lever Spring Bolt M6 x 25 [1x] |
| 2 | Manual Shaft Detent Lever Spring |
| 3 | A/Trans Control Wiring Harness Procedure Disconnect the wiring harness connector from the manual shift shaft position switch. |
| 4 | A/Trans Wiring Harness Procedure Disconnect the wiring harness connector from the A/Trans control wiring harness. |
| 5 | Manual Valve Procedure Disconnect the manual valve from the manual valve link. |
| 6 | Control Valve Solenoid Body Bolt M6 x 68 [7x]
NOTE:
Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated. Special Tools DT-48285 Valve Body Torx Plus Socket For equivalent regional tools, refer to Special Tools |
| 7 | Control Valve Solenoid Body Bolt M6 x 45 [4x]
NOTE:
Do not remove all the bolts in the control valve body assembly. Remove only the bolts indicated. Special Tools DT-48285 Valve Body Torx Plus Socket For equivalent regional tools, refer to Special Tools . |
| 8 | Control Valve Body Assembly
CAUTION:
Use care when handling the control valve body assembly. If dropped, damage to the control solenoid valve body assembly internal components may result.
|
| 9 | Output Speed Sensor Wiring Harness Bolt M6 x 25 [3x]
CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
NOTE:
Remove and DISCARD the bolts. Special Tools DT-48285 Valve Body Torx Plus Socket For equivalent regional tools, refer to Special Tools . |
| 10 | Output Speed Sensor Wiring Harness |
| 11 | Clutch Housing Fluid Passage Seal
NOTE:
DISCARD the seal.
|