Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Without W2E)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver or Passenger Seat Cushion Outer Finish Panel (Without W2E)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
1	Front Seat Cushion Outer Finish Cover Retainer (Qty: 2) CAUTION: Refer to Fastener Caution .
2	Front Seat Cushion Outer Finish Cover Procedure Disengage the seat back cushion finish panel straps and pull back the toe kick cover to gain access to the rear fastener. Remove the outer finish panel by pulling upward near the retainer clip locations. Disconnect the electrical connectors. If replacing the finish panel, transfer components as necessary.

Callout

Component Name

Preliminary Procedure
Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .

Front Seat Cushion Outer Finish Cover Retainer (Qty: 2)

CAUTION: Refer to Fastener Caution .

Front Seat Cushion Outer Finish Cover

Procedure

Disengage the seat back cushion finish panel straps and pull back the toe kick cover to gain access to the rear fastener.
Remove the outer finish panel by pulling upward near the retainer clip locations.
Disconnect the electrical connectors.
If replacing the finish panel, transfer components as necessary.