Driver or Passenger Seat Cushion Outer Finish Panel Replacement (With W2E)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driver or Passenger Seat Cushion Outer Finish Panel (With W2E)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Driver or Passenger Seat Removal and Installation Front Seat Cushion Front Finish Cover Replacement
1	Driver or Passenger Seat Cushion Outer Finish Cover Fastener (Qty: 2) CAUTION: Refer to Fastener Caution .
2	Driver or Passenger Seat Cushion Outer Finish Cover Procedure Disengage the seat back cushion finish panel straps and pull back the toe kick cover to gain access to the rear fastener. Remove the outer finish panel by pulling upward near the retainer clip locations. Disconnect the electrical connectors. If replacing the finish panel, transfer components as necessary.

Callout

Component Name

Preliminary Procedures

Driver or Passenger Seat Removal and Installation
Front Seat Cushion Front Finish Cover Replacement

Driver or Passenger Seat Cushion Outer Finish Cover Fastener (Qty: 2)

CAUTION: Refer to Fastener Caution .

Driver or Passenger Seat Cushion Outer Finish Cover

Procedure

Disengage the seat back cushion finish panel straps and pull back the toe kick cover to gain access to the rear fastener.
Remove the outer finish panel by pulling upward near the retainer clip locations.
Disconnect the electrical connectors.
If replacing the finish panel, transfer components as necessary.