LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> CTS Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Automatic Transmission - 8L45 (M5N) Or 8L90 (M5U) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Control Valve Body Replacement (M5N) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using DT-48285  Valve Body Torx Plus Socket install the valve body (3) and the valve body assembly bolts (1, 2) in the transmission.
    Fig 1: Valve Body Torx Plus Bolt Tightening Sequence
    GM3816870Courtesy of GENERAL MOTORS COMPANY
  2. Tighten the bolts (1 - M6 x 68) and bolts (2 - M6 x 45) to 9 N.m (80 lb in) in the sequence shown.
  3. Install the transmission fluid pump driven sprocket (1). Refer to automatic transmission fluid baffle and driven sprocket in Control Valve Assembly and Transmission Wiring Harness Installation .
    Fig 2: Retainer
    GM3817155Courtesy of GENERAL MOTORS COMPANY
  4. Install the manual shaft detent lever spring (2) and the manual shaft detent lever spring retaining bolt (1) then tighten to 12 N.m (106 lb in).
    Fig 3: Manual Shaft Detent Lever Spring
    GM3816495Courtesy of GENERAL MOTORS COMPANY
  5. Connect the manual valve (1) to the manual shift shaft position switch assembly linkage (2).
    Fig 4: Manual Valve
    GM3816802Courtesy of GENERAL MOTORS COMPANY
  6. Install the transmission fluid baffle (2). Refer to Transmission Fluid Baffle Replacement 
    Fig 5: Transmission Fluid Baffle
    GM3816731Courtesy of GENERAL MOTORS COMPANY
  7. Install the auxiliary fluid accumulator. Refer to Auxiliary Fluid Accumulator Replacement 
  8. Install the transmission fluid filter (4). Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement (Rear Wheel Drive)  and Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement (All Wheel Drive) 
    Fig 6: Transmission Fluid Filter
    GM3794350Courtesy of GENERAL MOTORS COMPANY
  9. Reprogram the transmission. Refer to Solenoid Valve Characterization Reprogramming
  10. Perform the service fast learn procedure. Refer to Transmission Service Fast Learn Procedure .
    NOTE:

    The Service Fast Learn procedure must be performed when one of the following repairs have been made to the vehicle. Failure to perform the procedure after one of the following repairs may result in poor transmission performance, as well as transmission DTCs being set:

    The service fast learn procedure must be performed when any of the following repairs has been made to the transmission.

    • Pressure regulating solenoid replacement
    • Valve body repair or replacement
    • Any service/repair in response to a shift quality concern
    • Any internal transmission service, repair, overhaul or replacement
    • Torque converter replacement
    • TCM replacement
    • Transmission assembly replacement
scientia non olet · About LEMON Manuals