LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> CTS Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Automatic Transmission - 8L45 (M5N) Or 8L90 (M5U) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement (M5U)

Automatic Transmission Range Selector Lever Replacement (M5U)

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Automatic Transmission Range Selector Lever (M5U)
GM4063672Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Apply the park brake.
  2. Shift the transmission into neutral.
  3. Transmission Heat Shield Replacement » Remove
  4. Disconnect the transmission range selector cable from the range selector cable lever ball stud.
    WARNING: After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.
1 Transmission Range Selector Cable Lever Nut
WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
CAUTION: Refer to Fastener Caution .

Tighten 
25 N.m (18 lb ft)
2 Transmission Range Selector Cable Lever
scientia non olet · About LEMON Manuals