LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2017 >> CTS Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Suspension System General Diagnosis) >> Diagnostic Information and Procedures >> Suspension Strut and Shock Absorber Testing - On Vehicle

Suspension Strut and Shock Absorber Testing - On Vehicle

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
1 Did you review the General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Suspension General Diagnosis 
2 Verify that the malfunction is present.
Does the vehicle operate normally?
System OK Go to Step 3 
3
NOTE: A light film of oil on the top portion of the reservoir is normal.
Inspect each shock absorber for external fluid leakage.Is the shock absorber leaking?
Go to Step 7  Go to Step 4 
4 Inspect the vehicle trim height. Refer to Trim Height Specifications .
Is the vehicle trim height correct?
Go to Step 5  Go to Step 6 
5
  1. Use your hands in order to lift up and push down each corner of the vehicle 3 times.
  2. Remove your hands from the vehicle.
Does the vehicle stop bouncing after 2 cycles?
Go to Step 8  Go to Step 7 
6 Replace the front spring or the rear spring.
Refer to the following:
Did you complete the repair?
Go to Step 8  -
7 Replace the strut or shock absorber.
Refer to the following:
Did you complete the repair?
Go to Step 8  -
8 Operate the vehicle in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3