Rear Side Door Sill Garnish Molding Replacement

WARNING: This page is about a different car, the 2016 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Side Door Sill Garnish Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the rear seat back bolster. Refer to Rear Seat Back Bolster Replacement Remove the rear seat back cushion, if equipped with without AM9 fixed seat back. Refer to Rear Seat Back Cushion Removal And Installation (40% With AM9) , Rear Seat Back Cushion Removal And Installation (60% With AM9) and Rear Seat Back Cushion Removal And Installation (Without AM9)
1	Rear Side Door Sill Trim Plate Clip
2	Rear Side Door Sill Trim Plate Retainer (Qty: 3) Procedure Slide the molding off of the retainers, replace the sill trim plate retainers, as needed.
3	Rear Side Door Sill Garnish Molding Assembly Procedure Use the appropriate plastic trim tool to aid in the removal of the rear side door sill garnish molding.