Front Bumper Fascia Replacement (With UV3)

Fig 1: Front Bumper Fascia

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Front Compartment Front Sight Shield Replacement Front Wheelhouse Liner Replacement Front Bumper Fascia Lower Stiffener Replacement
1	Front Bumper Fascia Bolt [10x] CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Front Bumper Fascia Screw [2x] Tighten 2.5 N.m (22 lb in)
3	Front Bumper Fascia Retainer [2x]
4	Front Bumper Fascia Procedure Carefully push a small nylon wedge between the fascia and the front fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the front fascia guide. Disconnect the electrical connectors. Disconnect the night vision camera washer hose. Transfer components as necessary.