High Beam Headlamps

When the low beam headlamps are ON and the turn signal/multifunction switch is placed in the high beam position, ground is applied to the BCM through the high beam signal circuit. The BCM responds to the high beam request by applying ground to the headlamp high beam relay control circuit which energizes the headlamp high beam relay. With the headlamp high beam relay energized, the switch contacts close allowing battery voltage to flow through the 3 pin high beam fuse to the high beam control circuits and on to the left and right high beam solenoid actuators located in each headlamp assembly. Once the high beam solenoid actuators are active, the high beam solenoid shutters open in each headlamp assembly exposing the remaining portion of the headlamp that was covered by the shutters illuminating the high beams at full intensity.