LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> XTS Livery >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 3.6L (LFX LF3) - Repair Instructions >> Repair Instructions >> Ignition Coil Replacement - Bank 2 (LF3) >> Installation Procedure

Installation Procedure

    Fig 1: Ignition Coils
    GM3331356Courtesy of GENERAL MOTORS COMPANY
  1. Install the ignition coil(s) (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the ignition coil bolt(s) (1).

    Tighten 

    Tighten the bolt(s) to 10 N.m (89 lb in)

    3. Fig 2: Engine Wiring Harness Electrical Connector(s)
    GM3331367Courtesy of GENERAL MOTORS COMPANY
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (2).
  4. For cylinder #4, connect the charge air cooler inlet pipe (left) to the charge air cooler cover. Refer to Charge Air Cooler Inlet Pipe Replacement - Left Side (LF3) .
  5. For cylinder #6, connect the charge air bypass valve - left side LF3, to the charge air cooler inlet pipe - left side. Refer to Charge Air Bypass Valve Replacement - Left Side (LF3) .
  6. Install the intake manifold cover - LF3. Refer to Intake Manifold Cover Replacement (LF3) .
scientia non olet · About LEMON Manuals