LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> XTS Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 (M7U), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (FWD) >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation (With J64)Tire and Wheel Removal and Installation (With J55) .
  3. Remove the rear catalytic converter. Refer to Three-Way Catalytic Converter Replacement (Front-LFX)Three-Way Catalytic Converter Replacement (Rear-LFX) .
  4. Using a suitable jack stand, support the rear of the powertrain.
    5. Fig 1: Rear Transmission Mount Through Bolt
    GM2199347Courtesy of GENERAL MOTORS COMPANY
  5. Remove the transmission mount to bracket through bolt (1).
    6. Fig 2: Transaxle Brace & Bolt
    GM2199343Courtesy of GENERAL MOTORS COMPANY
  6. Remove the transaxle brace bolt (1), then loosen bolt (2) until it no longer engages the transaxle.
  7. Remove the transaxle brace (3) with bolt (2) still retained in the brace.
    8. Fig 3: Transmission Mount To Transmission Bolts
    GM2199354Courtesy of GENERAL MOTORS COMPANY
  8. Remove the transmission mount bracket (1) to transmission bolts (2).
    9. Fig 4: Rear Mount To Frame Fasteners
    GM2199358Courtesy of GENERAL MOTORS COMPANY
  9. Remove the rear mount to frame fasteners (1, 2), then remove the mount and bracket from the vehicle.
scientia non olet · About LEMON Manuals