LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> XTS Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 (M7U), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Transmission Front Mount Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Transaxle Mount & Attachment Bolts
    GM2199370Courtesy of GENERAL MOTORS COMPANY
  1. Install the transaxle mount (1).
  2. Raise the vehicle.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the NEW transaxle mount bolts (2) and tighten to 62 N.m (46 lb ft).
    4. Fig 2: Identifying Front Transmission Mount Through Bolt
    GM2199369Courtesy of GENERAL MOTORS COMPANY
  4. Install the transaxle mount through bolt (1) and tighten to 100 N.m (79 lb ft).
  5. Install the wire harness retainer at the front transmission mount bracket.
  6. Remove the jack from the transmission.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals