Installation Procedure
- Install the transmission range selector lever cable to the vehicle.
- Install the transmission range selector lever cable grommet (1) to the cowl panel.
- Install the cable (4) to transmission control assembly.
- Connect the transmission range selector lever cable terminal (1) to the transmission control shift lever pin (2).
- Install the left front floor console extension panel from the console. Refer to Front Floor Console Extension Panel Replacement - Left Side .
- Position the front left carpet.
- Install the transmission range selector lever cable (2) to the cable bracket (3).
- Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin (2).
- Ensure that the shift lever and the transmission control are in the Park position. Secure the shift cable adjustable lock into place. Ensure that the adjustable lock lever is properly seated.
Locate the paint dot on the transmission range selector lever cable terminal (1) end. Ensure the paint dot faces the transmission control shift lever pin (2). If the paint dot is facing outward, the cable is NOT installed correctly.
Ensure that the transmission range selector lever cable terminal end (1) is firmly seated onto the shift lever pin (2) by pulling on the terminal end using a single finger pull. The cable should not be easily disconnected.
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.