Installation Procedure
- Install a NEW control solenoid valve assembly filter plate (1).
- Install the control solenoid valve body and TCM assembly (5).
- Rotate the control solenoid valve spring (7) into position.
- Hand tighten the following fasteners.
- The 4 control valve body bolts (1) M6 x 80.
- The control valve body bolt (6) M6 x 55.
- The 3 control valve body bolts (2) M6 x 95.
- The control valve body bolt (3) M6 x 42.
- The 2 control valve body bolts (4) M6 x 65.
- Tighten the bolts (1, 2, 3, 4, 6) in the specified sequence to 12 N.m (106 lb in).
- Connect the input speed sensor electrical connector (1).
- Connect the output speed sensor electrical connector (2).
- Connect the shift position switch electrical connector (3).
- Install the control valve body cover. Refer to Control Valve Body Cover Replacement .
- Program the module. Refer to Control Module References .
CAUTION:
Use care when removing or installing the filter plate assembly. A broken or missing retaining tab may not adequately secure the filter plate to the control solenoid valve assembly, resulting in possible damage or contamination.
CAUTION:
Refer to Fastener Caution .
NOTE:
Install all bolts before tightening, then tighten in specified sequence.