LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> XTS Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 6T70 (M7U), 6T75 (M7V), Or 6T80 (Mhm) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement

Automatic Transmission Range Selector Lever Replacement

Fig 1: Identifying A/T Range Selector Lever Components
GM1830040Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Set the park brake and chock the wheels.
  2. Remove the Engine Control Module (ECM). Engine Control Module Replacement (LFX)Engine Control Module Replacement (LF3)
  3. WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  4. Disconnect the range selector cable from the range selector lever.
1 Transmission Range Selector Lever Nut
WARNING:

Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.

CAUTION:

Refer to Fastener Caution .


Tighten 
20 N.m (15 lb ft)
2 Transmission Range Selector Lever