LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> SRX Performance, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.0L (LFW) Or 3.6L (LFX) - Repair Instructions - On Vehicle >> Repair Instructions - On Vehicle >> Valve Stem Oil Seal and Valve Spring Replacement - Left Side >> Installation Procedure

Installation Procedure

    Fig 1: Valve Stem Oil Seal Removal/Installation
    GM1338340Courtesy of GENERAL MOTORS COMPANY
  1. Use the EN-46116  remover/installer (1) in order to install the valve stem seal (2).
    2. Fig 2: Valve Spring
    GM902899Courtesy of GENERAL MOTORS COMPANY
  2. Install the valve spring.
  3. Install the valve spring retainer.
    4. Fig 3: Installed Valve Spring Compressor Tool
    GM1338337Courtesy of GENERAL MOTORS COMPANY
  4. Install the EN-46110  compressor above the applicable valve spring as shown.

    Tighten the EN-46110  compressor nut (2).

    5. Fig 4: Valve Spring Keepers
    GM902903Courtesy of GENERAL MOTORS COMPANY
  5. Install the valve spring keepers.
  6. Remove the EN-46110  compressor.
  7. Disconnect the EN-39313  adapter from the compressed air source.
  8. Remove the EN-39313  adapter.
  9. Install the spark plugs. Refer to Spark Plug Replacement .
  10. Install the rocker arms. Refer to Valve Rocker Arm Replacement - Left Side .
  11. Remove the EN-46106  tool in order to prevent crankshaft rotation.
  12. Install the starter motor. Refer to Starter Replacement .
scientia non olet · About LEMON Manuals