LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2016 >> SRX Performance, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.0L (LFW) Or 3.6L (LFX) - Repair Instructions - Off Vehicle >> Repair Instructions - Off Vehicle >> Water Pump Removal

Water Pump Removal

Fig 1: Water Pump Components
GM4596862Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Water Pump Pulley Bolt (Qty: 4)

Procedure

  1. Install the EN-46104  Water Pump Pulley Holding Tool onto the water pump pulley mounting holes.
  2. Remove the water pump pulley bolts.
  3. Remove the EN-46104  Water Pump Pulley Holding Tool from the water pump pulley.

Special Tools 
EN-46104  Water Pump Pulley Holding Tool
Equivalent regional tools: Special Tools
2 Water Pump Pulley
3 Water Pump Bolt (Qty: 6)
CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

NOTE:

Remove and DISCARD the bolts.
4 Water Pump
5 Water Pump Gasket
NOTE:

Remove and DISCARD the gasket.
scientia non olet · About LEMON Manuals