Automatic Transmission Flex Plate Removal

Special Tools 

EN 46106  Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools .

Fig 1: Flywheel Holding Fixture
Courtesy of GENERAL MOTORS COMPANY
1. Install the EN 46106  holder through the starter mounting hole.
Fig 2: Automatic Transmission Flex Plate & Bolts
Courtesy of GENERAL MOTORS COMPANY
2. Remove the 8 automatic transmission flex plate bolts (1).
3. Remove the automatic transmission flex plate (2).
Fig 3: Flywheel Holding Fixture
Courtesy of GENERAL MOTORS COMPANY
4. Remove the EN 46106  holder.