Installation Procedure
- Assemble the intake manifold if needed. Refer to Intake Manifold Assemble (LFW or LFX) .
- Install the NEW intake manifold gasket (1).
- Install the intake manifold assembly (2).
- Install the intake manifold bolts (1).
- Tighten the intake manifold bolts in the sequence shown.
- Tighten the intake manifold bolts in sequence to 25 N.m (18 lb ft).
- Tighten the intake manifold bolts a second pass in sequence to 25 N.m (18 lb ft).
- Install the fuel pipe shield. Refer to Fuel Pipe Shield Replacement .
- Position wire harnesses and connect as necessary.
- Connect the EVAP hose to the upper intake manifold and EVAP solenoid.
- Connect the PCV tube assembly (1) to the upper intake manifold and the right camshaft cover.
- Install coolant hose.
- Install the coolant air bleed pipe. Refer to Engine Coolant Air Bleed Pipe Replacement (LFW, LFX) .
- Install the power steering fluid reservoir upper bracket.
- Install the power brake booster vacuum check valve and hose. Refer to Power Brake Booster Vacuum Check Valve and Hose Replacement .
- Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
- Install intake manifold cover. Refer to Intake Manifold Cover Replacement .
CAUTION:
Refer to Fastener Caution .