Engine Support Fixture

Special Tools

• EN-28467-B  Universal Engine Support Fixture
• EN-28467-161  Engine Support Fixture Adapters
• J-36857  Bracket

For equivalent regional tools, refer to Special Tools .

1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
Fig 1: Engine Lift Bracket (Right Cylinder Head)
Courtesy of GENERAL MOTORS COMPANY
CAUTION:

Refer to Fastener Caution .

3. Use a grade 10.9 bolt to install a J-36857  bracket to the left cylinder head in the location shown. Tighten the bolt to 65 N.m (48 lb ft).
Fig 2: Engine Lift Bracket (Left Cylinder Head)
Courtesy of GENERAL MOTORS COMPANY
4. Using a grade 10.9 bolt with a 25 mm (1 in) spacer, install the J-36857  bracket to the right cylinder head in the location shown. Tighten the bolt to 65 N.m (48 lb ft).
Fig 3: Support Fixture Between Fender And Body
Courtesy of GENERAL MOTORS COMPANY
5. Install the EN-28467-161  legs to the EN-28467-B  support fixture between the fender and the body.
Fig 4: Special Tool Support Fixture
Courtesy of GENERAL MOTORS COMPANY
6. Install the support hook (1) to the EN-28467-B  support fixture (2).
7. Raise the engine to release the pressure off of the engine mounts.
8. Reverse the procedure for removal.