Lift Plate and Holding Fixture Installation
| Callout | Component Name |
|---|---|
| 1 | DT-47811-A
Transmission Lift Plate
WARNING:
Handle with care, the transmission assembly weighs over 90.7 kg (200 lbs). Bodily injury could occur if not handled properly.
NOTE:
After Installation of lift plate, raise the transmission with an overhead hoist. Tighten 12 N.m (9 lb ft) Special Tools DT-47811-A Transmission Lift Plate For equivalent regional tools, refer to Special Tools . |
| 2 | DT-46625
Transmission Holding Fixture
CAUTION:
Refer to Fastener Caution .
NOTE:
Adjust mounting block on fixture to match bosses on case, then tighten bolts to: Tighten 13 N.m (10 lb ft) Special Tools DT-46625 Transmission Holding Fixture For equivalent regional tools, refer to Special Tools . |