LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2015 >> CTS V, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Engine Controls And Fuel - 6.2L (LSA) - Repair Instructions (Coupe) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of EVAP Canister Retaining Nuts
    GM785820Courtesy of GENERAL MOTORS COMPANY
  1. Complete the following in order to install the EVAP canister:
    1. Insert the fresh air tube and tab on the canister forward into the body brace.
    2. Rotate the rear of the canister up over the 2 weld studs on the floor pan.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the EVAP canister retaining nuts and tighten to 6 N.m (53 lb in).
    3. Fig 2: Identifying EVAP Hoses At EVAP Canister
    GM785817Courtesy of GENERAL MOTORS COMPANY
  3. Connect the EVAP hoses to the EVAP canister.
  4. Connect the electrical connector to the EVAP canister.
  5. Install the rear frame. Refer to Rear Frame Replacement .
scientia non olet · About LEMON Manuals