LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2015 >> CTS V, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges (Coupe) >> Diagnostic Information and Procedures >> DTC P2067: Fuel Level Sensor 2 >> Circuit/System Testing

Circuit/System Testing

NOTE:
  • Circuit/System Verification must be performed before proceeding with Circuit/System Testing.
  • If equipped, the following tests can be performed at an in-line connector. See schematics for the corresponding terminals to test at.
  1. Ignition OFF, disconnect the harness connector at the secondary fuel level sensor.
  2. Ignition ON, scan tool installed, verify that the scan tool Fuel Level Sensor Left Tank parameter is greater than 4.5 V.
    • If less than the specified range, test the secondary signal circuit terminal A for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, perform the fuel level sensor component test before replacing the secondary fuel level sensor.
scientia non olet · About LEMON Manuals