Heater and Air Conditioning Remote Control Replacement

Fig 1: Heater and Air Conditioning Remote Control Module

Courtesy of GENERAL MOTORS COMPANY

Call out	Component Name
Preliminary Procedure Remove the right side instrument panel insulator hole cover. Refer to Instrument Panel Insulator Hole Cover Replacement . NOTE: When removing the instrument panel lower trim panel insulator for any reason, it is required that the connector to the HVAC module be disconnected. If the vehicle battery has NOT been disconnected, when reinstalling or reconnecting the module, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the HVAC module.
1	Heater And Air Conditioning Remote Control Module Procedures Disconnect the heater and air conditioning remote control module connectors. Perform the HVAC system control module programming and setup procedure. Refer to HVAC System Control Module Programming and Setup . Perform the actuator re-calibration procedure. Refer to Actuator Recalibration .

Call out

Component Name

Preliminary Procedure
Remove the right side instrument panel insulator hole cover. Refer to Instrument Panel Insulator Hole Cover Replacement .

NOTE:

When removing the instrument panel lower trim panel insulator for any reason, it is required that the connector to the HVAC module be disconnected. If the vehicle battery has NOT been disconnected, when reinstalling or reconnecting the module, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the HVAC module.

Heater And Air Conditioning Remote Control Module

Procedures

Disconnect the heater and air conditioning remote control module connectors.
Perform the HVAC system control module programming and setup procedure.
Refer to HVAC System Control Module Programming and Setup .
Perform the actuator re-calibration procedure.
Refer to Actuator Recalibration .