Rear Compartment Lid Adjustment

Fig 1: Rear Compartment Lid

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .
1	Rear Compartment Lid CAUTION: Refer to Fastener Caution Procedure Loosen the rear compartment lid hinge bolts (Qty: 4) to adjust the rear compartment lid. Adjust the rear compartment lid in order to obtain an even gap between the rear compartment lid and the quarter outer pan the rear fog lamp and the rear bumper fascia and so that the rear compartment lid is flush with the quarter outer panel, the rear fog lamp and the rear bumper fascia. Adjustment Rear compartment lid to quarter outer panel (a) 3.0 mm ± 0.75 mm (0.12 in ± 0.03 in) Tail lamp to rear compartment lid (b) 3.0 mm ± 1.0 mm (0.12 in ± 0.04 in) Rear compartment lid to rear bumper fascia (c) 5.5 mm ± 1.5 mm (0.22 in ± 0.06 in) Tighten 9 (80 lb in)

Callout

Component Name

Preliminary Procedure
Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement .

Rear Compartment Lid

CAUTION:

Procedure

Loosen the rear compartment lid hinge bolts (Qty: 4) to adjust the rear compartment lid.
Adjust the rear compartment lid in order to obtain an even gap between the rear compartment lid and the quarter outer pan the rear fog lamp and the rear bumper fascia and so that the rear compartment lid is flush with the quarter outer panel, the rear fog lamp and the rear bumper fascia.
Adjustment
- Rear compartment lid to quarter outer panel
  (a) 3.0 mm ± 0.75 mm (0.12 in ± 0.03 in)
- Tail lamp to rear compartment lid
  (b) 3.0 mm ± 1.0 mm (0.12 in ± 0.04 in)
- Rear compartment lid to rear bumper fascia
  (c) 5.5 mm ± 1.5 mm (0.22 in ± 0.06 in)

Tighten
9 (80 lb in)