Access Hole Plugs, Fill and Drain Plug, Vent, 2/4 Wheel Drive Actuator, Actuator Shaft Position Sensor, and Vehicle Speed Sensor Removal
WARNING: This page is about a different car, the 2014 GMC Yukon XL 1500, 2014 GMC Yukon, 2014 Chevrolet Tahoe, and 2014 Chevrolet Suburban 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Access Hole Plugs, Fill and Drain Plug, Vent, 2/4 Wheel Drive Actuator, Actuator Shaft Position Sensor and Vehicle Speed Sensor
Access Hole Plugs, Fill and Drain Plug, Vent, 2/4 Wheel Drive Actuator, Actuator Shaft Position Sensor, and Vehicle Speed Sensor Removal
| Callout | Component Name |
|---|---|
| 1 | Transfer Case Actuator Shaft Position Sensor Bolt/Screw |
| 2 | Transfer Case Actuator Shaft Position Sensor Assembly |
| 3 | Transfer Case Actuator Shaft Position Sensor O-Ring Seal |
| 4 | Transfer Case Two/Four Wheel Drive Actuator Bolt/Screw |
| 5 | Transfer Case Two/Four Wheel Drive Actuator Assembly |
| 6 | Transfer Case Oil Drain Plug |
| 7 | Transfer Case Oil Fill Plug |
| 8 | Transfer Case Vent
NOTE:
Remove ONLY if the vent pipe is damaged. |
| 9 | Vehicle Speed Sensor Assembly |
| 10 | Vehicle Speed Sensor O-Ring Seal |
| 11 | Transfer Case Access Hole Plugs (Qty: 2) |
| 12 | Transfer Case Vibration Dampener Nut- Model Dependent
NOTE:
During nut removal if the stud rotates, use a second tool to retain the stud. |
| 13 | Transfer Case Vibration Dampener - Model Dependent |
| 14 | Transfer Case Vibration Dampener Stud - Model Dependent
NOTE:
Note the location and length of the studs for reassembly. |