LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> Escalade Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Transfer Case - Mp 3023/3024-NQH) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Rear Output Shaft Assembly

Rear Output Shaft Assembly

WARNING: This page is about a different car, the 2014 GMC Yukon XL 1500, 2014 GMC Yukon, 2014 Chevrolet Tahoe, and 2014 Chevrolet Suburban 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Assembly
GM2370846Courtesy of GENERAL MOTORS COMPANY
Rear Output Shaft Assembly

Callout Component Name
1 Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
2 Transfer Case Four Wheel Drive Clutch Housing
3 Transfer Case Front Output Shaft Drive Sprocket
4 Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
5 Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
6 Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
NOTE:

Ensure the retaining ring is installed into the correct retaining ring groove on the rear output shaft.
7 Transfer Case Oil Pump Assembly
8 Transfer Case Rear Output Shaft Speed Reluctor Wheel
9 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring - Present on Non-Hybrid Applications Only
10 Transfer Case Rear Output Shaft Rear Bearing Assembly

Procedure:

  1. Use an arbor press or suitable installer to install the bearing to the rear output shaft.
  2. Ensure the retaining ring groove in the outer race is positioned toward the rear.
11 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
scientia non olet · About LEMON Manuals