Back Body Opening Upper Applique Replacement

Fig 1: View Of Back Body Opening Rear Applique & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
1	Rear Applique Screw (Qty: 3) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in) Position the center screw to the applique first, followed by the hinge nuts second. Install the outer screws last and torque the screws in the same sequence.
2	Rear Applique Nut (Qty: 2) Tighten 9 N.m (80 lb in) TIP: Disconnect the electrical connector.
3	Rear Applique