LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> Escalade Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Endgate Adjustment >> Adjustment Procedure

Adjustment Procedure

Fig 1: Adjusting Endgate
GM1855768Courtesy of GENERAL MOTORS COMPANY
  1. With the endgate closed, determine the amount of adjustment will be needed.
  2. If adjustment is necessary, remove the endgate. Refer to Endgate Replacement (Escalade EXT) .
  3. Mark the position of the hinges with a grease pencil.
    4. NOTE:

    Use a screwdriver to move the adjustment hinge.

  4. Loosen the endgate bolts and adjust the endgate hinges by moving the hinges in the following directions.
    • Upward or downward
    • Inward or outward
  5. Reinstall the endgate and determine if any further adjustments are needed.
    6. CAUTION:

    Refer to Fastener Caution .

  6. When the proper adjustments are set, tighten the hinge bolts to 40 N.m (30 lb ft).
scientia non olet · About LEMON Manuals