LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2014 >> Escalade Base, AWD >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW >> Repair Instructions >> Rear Wheel Speed Sensor Ring Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel) , Tire and Wheel Removal and Installation (8-Lug Wheel) .
  3. Remove the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Ring Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) , Rear Axle Housing Cover and Gasket Replacement (10.5 Inch Axle) .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    6. Fig 1: Removing The Wheel Speed Sensor Ring From The Axle Housing
    GM889095Courtesy of GENERAL MOTORS COMPANY
  6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J-45857  tone wheel and/or bearing remover (1) and the J-2619-01  slide hammer (2).
scientia non olet · About LEMON Manuals