LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Valve Lifter Replacement (Without AFM) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Valve Lifter Guides, Cylinder Head & Bolts
    GM1403318Courtesy of GENERAL MOTORS COMPANY
  1. Remove the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side , or Cylinder Head Replacement - Right Side .
  2. Remove the valve lifter guide bolts (211).
  3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the locating tab on the engine block.
    4. Fig 2: Valve Lifter Guides & Bolts
    GM1403319Courtesy of GENERAL MOTORS COMPANY
  4. Remove the valve lifters (209) from the guide (210).
  5. Organize or mark the components so that they can be installed in the same location from which they were removed, if required.
  6. Clean and inspect the valve lifters, if required. Refer to Valve Lifter and Guide Cleaning and Inspection .
scientia non olet · About LEMON Manuals