LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator, Tube Bolt, Indicator Tube & O-Ring Seal
    GM1658141Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil level indicator (418).
  2. Remove the oil level indicator tube bolt (419).
  3. Remove the oil level indicator tube (420) from the engine block.
    4. NOTE:

    The O-ring seal may be reused if not cut or damaged.

  4. Inspect the O-ring seal for cuts or damage.
  5. Remove the O-ring seal (421) from the tube, if required.
scientia non olet · About LEMON Manuals