LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Right Side (except L96) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  5. Remove the battery cable attachment on the frame.
  6. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
  7. Remove exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Right Side .
  8. Remove the starter. Refer to Starter Replacement .
    9. Fig 1: View Of Engine Mount To Frame Bolts
    GM1701796Courtesy of GENERAL MOTORS COMPANY
  9. Remove the engine mount to frame bolts (1).
  10. Position an adjustable jack and a block of wood under the engine oil pan and slightly raise the engine.
    11. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701799Courtesy of GENERAL MOTORS COMPANY
  11. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
    12. Fig 3: View Of Engine Mount
    GM1701802Courtesy of GENERAL MOTORS COMPANY
  12. Remove the engine mount through the rear of the wheelhouse opening.
scientia non olet · About LEMON Manuals