Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the engine mount to the engine block.
- Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 (37 lb ft).
- Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
- Remove the adjustable jack and block of wood from the engine oil pan.
- Clean the threads of the engine mount to engine mount bracket bolts using denatured alcohol or equivalent.
- Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the engine mount to engine mount bracket bolts and tighten to 65 N.m (48 lb ft).
- Install the starter. Refer to Starter Replacement
- Install exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Right Side .
- If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
- Install the battery cable attachment on the frame.
- Install the right wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
- Lower the vehicle.
- Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .