LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side (except L96) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
    5. Fig 1: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  5. Remove the engine mount to frame bolts (1).
  6. Remove exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side .
  7. Remove the upper (long) and lower (double joint) I-shaft. Refer to Upper Intermediate Steering Shaft Replacement .
  8. Position an adjustable jack and a block of wood under the engine oil pan and raise the engine slightly.
    9. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701533Courtesy of GENERAL MOTORS COMPANY
  9. If equipped, remove the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
  10. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
    11. Fig 3: View Of Engine Mount
    GM1701535Courtesy of GENERAL MOTORS COMPANY
  11. Remove the engine mount toward the front of the vehicle.
scientia non olet · About LEMON Manuals