Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the engine mount to the engine block.
- Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 (37 lb ft).
- If removed, install the electronic suspension front position sensor attachment bolt and reposition. Refer to Electronic Suspension Front Position Sensor Replacement .
- Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
- Remove the adjustable jack and block of wood from the engine oil pan.
- Clean the threads of the engine mount to frame bolts (1) using denatured alcohol or equivalent.
- Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the engine mount to frame bolts and tighten to 65 (48 lb ft).
- Install the upper (long) and lower (double joint) I-shaft. Refer to Upper Intermediate Steering Shaft Replacement .
- Install exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side .
- Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
- Lower the vehicle.
- Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .