LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement - Accessory >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner & Bolts
    GM1696654Courtesy of GENERAL MOTORS COMPANY
  1. Position the drive belt tensioner to the water pump.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install and tighten the drive belt tensioner bolts.

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals