LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW CMP actuator solenoid valve (234).

    With the CMP actuator properly positioned onto the camshaft, the CMP actuator solenoid valve can be threaded completely into the camshaft using light hand pressure. Tighten by hand until snug.

    2. Fig 2: Tightening The CMP Actuator Solenoid Valve
    GM1658245Courtesy of GENERAL MOTORS COMPANY
  2. Tighten the CMP actuator solenoid valve.
    1. Tighten the CMP actuator solenoid valve a first pass to 65 N.m (48 lb ft).
    2. Tighten the CMP actuator solenoid valve a final pass an additional 90 degrees using the J 45059  meter.
    3. Fig 3: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS COMPANY
  3. Remove the J 42386-A  holding tool (1).
  4. Install the CMP actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
  5. Install the starter. Refer to Starter Replacement .
scientia non olet · About LEMON Manuals