LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Engine Flywheel & Bolts
    GM832979Courtesy of GENERAL MOTORS COMPANY
  1. Remove the automatic transmission. Refer to Transmission Replacement for the 6L45/6L50/6L80/6L90 transmission.
    2. NOTE:

    Note the position and direction of the engine flywheel before removal.

  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS COMPANY
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS COMPANY
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals