LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2013 >> Escalade Hybrid, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Tow/Haul Switch/Indicator Always On or Inoperative >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON, cycle the Tow/Haul switch while observing the Tow/Haul switch parameter on the scan tool in the Transmission Controls Data list. The Tow/Haul switch parameter should change states from NO to YES, or YES to NO with each cycle of the switch.
  2. Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
scientia non olet · About LEMON Manuals